SettingsProcessingGroupFiltersGroupHoleGroupRepairGroup Class

Constructor

Enable or disable hole repair.

Relative diameter of holes to fill. Increasing this will fill more points, but require more computation time. The maximum allowed hole size scales with distance, so that we allow filling larger holes at greater distances, measured in mm.

Level of strictness when considering if a point should be filled. A higher level of strictness requires a missing point to be surrounded by valid points on more sides in order to be filled. Increasing this will fill fewer points, but it will be less likely to fill gaps that are not circular, for example between two edges.

Create a clone (deep copy) of the current instance

Create a clone (deep copy) of the current instance and invoke delegate on the clone

Get string representation of the object