CameraApplyNetworkConfiguration Method

public void ApplyNetworkConfiguration(
	NetworkConfiguration networkConfiguration
)

Public Sub ApplyNetworkConfiguration ( 
	networkConfiguration As NetworkConfiguration
)

public:
void ApplyNetworkConfiguration(
	NetworkConfiguration^ networkConfiguration
)

`ApplyNetworkConfiguration` will block until the camera has finished applying the network configuration, or throw an exception if the camera does not reappear on the network before a timeout occurs. `ApplyNetworkConfiguration` can be used even if the camera is inaccessible via TCP/IP, for example a camera that is on a different subnet to the PC, or a camera with an IP conflict, as it uses UDP multicast to communicate with the camera. `ApplyNetworkConfiguration` can also be used to configure cameras that require a firmware update, as long as the firmware supports network configuration via UDP multicast. This has been supported on all firmware versions included with SDK 2.10.0 or newer. This method will throw an exception if the camera firmware is too old to support UDP multicast. `ApplyNetworkConfiguration` will throw an exception if the camera status (see Status) is "Busy", "Connected", "Connecting" or "Disconnecting". If the status is "Connected", then you must first call Disconnect before calling this method.